Recessed

Super Miniature 1/4" (6.5mm)

Download Cutsheet BA-71 The GRI 50RS Series is a 1/4″ diameter switch designed for applications where a miniature recessed switch set is required. Only .562 inches in length, the switch is able to be recessed in places where a standard switch is too large. The 50RS series is also widely used in the manufacture of […]

Continue Reading

Miniature Flange Switch 3/8″ (9.5mm)

Download PDF Cutsheet BA-82 The G.R.I. recessed “shortie” switch set is designed for applications where a 3/8″ press to fit set is needed but space limitations will not allow for a full length set to be installed. With the 5/8″ 20RS-12, or the .930″ 20RS-T, the installer is able to protect openings that otherwise would […]

Continue Reading

Miniature 1/4″ (6.5mm)

Download Cutsheet BA-86 The 50R and 50RF Series are 1/4″ diameter switch sets designed for applications where a small diameter recessed switch set is required. This makes the set desirable in residential installations where no sign of an alarm system should be seen or where there is not room to install a larger diameter switch […]

Continue Reading

Flange Switch Set 3/8″ (9.5mm)

Download Cutsheet BA-65 The 20F and 20 OF Series are a flush mount design that enable the installer to combine the security of a screw mount flanged switch with the concealment of a press fit switch. They have been used in hollow aluminum frames where inadequate material depth will not reliably retain a press fit […]

Continue Reading

Switch 3/4″ (19mm)

Download Cutsheet BA-59 The 120T/4473 requires that a 3/4″ hole be drilled for the switch and 3/8″ hole for the magnet. The 3/4″ switch mounting is desirable since the extra wire and connections can be more easily inserted into the larger hole for concealment. Also, should the need arise for testing or replacement, it would […]

Continue Reading

Switch 1/2″ (13mm)

Download Cutsheet BA-159 Larger than 3/8″ but smaller than 3/4″, G.R.I introduces their newest innovative switch design, the one-half inch diameter, flush mount, 150-12. This new design is in response to requests from our customers for a switch that would give them additional “working room” for extra wire, E.O.L. resistors, etc., yet would more readily […]

Continue Reading

Short Switch 1/2″ (13mm)

Download Cutsheet BA-226 Larger than 3/8” but smaller than 3/4”, the GRI 150RS Series is a one-half inch diameter, flush mount contact. This  1/2” diameter design allows additional “working room” for extra wire, E.O.L. resistors, etc. Manufactured from a  special polyvinyl material, the unique collar design will “press-fit” into hollow core aluminum or vinyl clad […]

Continue Reading



Press Fit Switch 3/8″ (9.5mm)

Download Cutsheet BA-65 The 20F and 20 OF Series are a flush mount design that enable the installer to combine the security of a screw mount flanged switch with the concealment of a press fit switch. They have been used in hollow aluminum frames where inadequate material depth will not reliably retain a press fit […]

Continue Reading